Large Waterproof Case for Wire-Out Electronics - AQ558
Large Waterproof Case for Wire-Out Electronics - AQ558
Couldn't load pickup availability
Description
Our largest case in the range – designed for the largest radio mics as well as specialist electronic devices. Check size guide.
Also works with pulmonary hypertension pumps.
This case is designed for electronics which require a thin wire to be connected to them at all times. The special wire-thru clamp at one end allows that wire to stay connected, and be waterproof. The case is usually used by professionals with specialist electronic devices, but could be used for a permanently connected small tablet, large phone or audio player.
Key Features
- Use all buttons and switches through the case
- Like most of our cases it'll float if you drop it in the drink
- Feed out a wire of up to 3.5mm diameter from the case
- The seams are high-frequency welded to form a super-strong bond
- Waterproofness Warning!: This case features our 'TC' Aquaclip which makes the case waterproof to IPX6 (a quick dunking should be fine, but not prolonged immersion).
Can people swim with it? Our testing shows that the TC clamp will let a tiny amount of water in after a period of total immersion. So the best advice we can give is to wear it in the small of your back if you’re swimming on your front, and on your tummy if you’re swimming on your back, so that it spends as little time submerged as possible. We are talking here about splashing around in the pool or the sea, but we are NOT talking about endurance/long-distance swimming.
Important Notes Cases with this clamp are for surface use only, but will offer protection from temporary submersion. They are not recommended for prolonged immersion. When not using the case leave the TC clamp open. If not the wire or tube could eventually cause a permanent distortion of the foam, risking leakage. As long as you follow this instruction the clamp will be watertight with or without a wire/tube. The maximum thickness of wire/tube around which the TC clamp will seal is 1/10th inch (3.5mm).
Share
